How do I connect more than one sender and/or receiver?

0
Started ‎09-13-2013 by
Modified ‎09-13-2013 by

Question

How do I connect more than one sender and/or receiver?

Answer

You will need to connect each sender and/or receiver to the Rocketboost network hub device. The hub device will be the device with the green power indicator. 

 

To join or pair devices:

  1. Make sure the antennas are raised on the sender and receiver devices.
  2. On the new sender or receiver device, make sure the HUB STATUS or HUB ENABLE is set to DISABLE.
  3. Connect the power adapter to the DC IN jack on the new sender or receiver device and into a power outlet. The sender or receiver device automatically turns on.
  4. Press and hold the POWER/JOIN BUTTON the hub device for more than three seconds to put it into joining mode for 30 seconds. The power indicator light starts blinking rapidly.
  5. Press and hold the POWER/JOIN BUTTON on the new sender or receiver device for more than three seconds to put it in joining mode. The power indicator light starts blinking rapidly. Joining mode stays active for 30 seconds.
  6. The power indicator lights steadily if the joining was successful.
  7. The power indicator blinks slowly if the joining was not successful. Repeat the joining process.
  8. Repeat these steps to connect additional sender or receiver devices. NOTE: You can have up to 5 senders and 9 receivers in a Rocketboost Network.
Contributors